RESEARCH CONCEPTS RC3000 Especificações descarregar pdf (Página 2)

Note that the cable service loop at the back of the controller should be long enough to allow the unit to be pulled out of its

mounting rack with the cabling attached to perform internal adjustments. Also note that the controller’s J1, J3, J6, J7, and

J10 connectors are identical to those on the back of the RC8097 controller. A back panel diagram is included in the

appendix of this document.

The following table describes the connectors on the back of the RC3000.

Designation Type Function

J1 DB15 female az/el/pol position sense

J2 DB15 female AGC port (RC3000TRK)

J3 DB15 female limit switches

J4 DB15 male Pulse sensor input (RC3000TRK)

J5 DB9 female Serial Comm. Port (RC3000CRC

J6 IEC fused Power Entry

J7 Amphenol 22-20S az/el/pol motors

J8 Amphenol 126-221 HPA disable and accessories

J9-GPS DB9 female on dongle GPS & cable, (RC3000GPS)

J9-FG DB9 female on dongle FG Compass & cable (RC3000FG)

J10 DB25 female Handheld Remote Control (RC3000HRC)

J11 F female Block LNB signal for auto peak

The following table lists the types of cable employed in the cabling kits produced by RCI.

Cable Type Cable Configuration Controller Wiring Harness Circuit

Alpha 2432C 2 x 16 AWG shielded with bare drain wire Az/El/Pol Motors

Belden 9770 3 x 22 AWG shielded with bare drain wire Az/Pol Potentiometer and Single Phase pulse

position encoders.

Alpha 2404C 4 x 22 AWG shielded with bare drain wire Elevation Inclinometer and Limit Switches

(containing two limit switch circuits, i.e.

elevation up and elevation down)

Alpha 1292C 2 x 22 AWG shielded with bare drain wire Limit Switches

Power Entry

Connector J6 accepts an IEC type AC power plug. RC3000 controllers can be configured at the factory for either 115 or 230

VAC operation. The AC line cord supplied with the controller is appropriate for the controller’s AC power configuration. The

controller’s AC line voltage configuration can be determined by viewing the window on the power entry module. The window

will either display ‘115’ or ‘230’.

The RC3000A can be configured by the user in the field for operation at either 115 or 230 VAC line voltage.

Use the following procedure to re-configure the RC3000A’s AC power configuration …

1. Switch off the controller.

2. Remove the IEC power cord from the back panel entry module.

3. With a small, straight bladed screw driver remove the fuse drawer and the fuse from the power entry module.

1 2 3 4 5 6 7 ... 16 17

Sem comentários

RESEARCH CONCEPTS RC3000 Especificações Página 2